Sea Recovery Ultra Whisper Compact 400, Owner'S Manual

Page: 45 / 120

4. Product Flow
–
Product water flow in l/min or GPM
5. Brine Flow
–
Brine flow in l/min or GPM
6. Water Quality
–
Salinity (water status) in ppm
7. Total Hours
–
High pressure pump/R.O. BOOST hour meter (counted in seconds but shown in whole
hours)
8.
Tank Full
–
Yes or no
9. Tank Empty
–
Yes or no
10. Booster Relay - Booster pump on or off
11. FWF Relay
–
Fresh Water Flush on or off
12. HP Relay
–
High pressure pump on or off
13. DV Relay
–
Diversion valve on or off
14. UV Relay
–
Ultraviolet on or off
15. Supply Voltage
–
volts (used only for diagnostics)
16. Version
–
software version
Configuration (Change) Menu
This menu shows a list of configuration parameters that can be changed by the operator. Press the CYCLE
button and hold for 5 seconds to view this menu and CYCLE again to scroll through the menu items. Every
time CYCLE is pressed, the next item is shown. Holding the CYCLE button for more than 5 seconds selects the
displayed menu item. Note that this menu does not allow the operator to monitor the state of these configuration
parameters. Please use the Configuration (Read) Menu to do so.
1. Unit
–
units (metric or US)
2. Low Pressure 1 Inst
–
S1 Lo pressure sensor installed (yes or no)
3. Low Press 2 Inst
–
S2 Lo pressure sensor installed (yes or no)
4. Prod Flow Inst
–
Product flow meter installed (yes or no)
5. Brine Flow Inst
–
Brine flow meter installed (yes or no)
6. Tank Full Inst
–
Tank level full sensor installed (yes or no)
7. Tank Empty Inst
–
Tank level empty sensor installed (yes or no)
8. FWF Delay
–
High pressure pump stop to FWF delay (HH:mm: ss)
9. Time to AutoShut
–
Auto shutdown after X hours in state FWP (HH:mm:ss)
10. AutoShut Time
–
Auto shutdown after time (yes or no)
11. AutoShut Tank
–
Auto shutdown on tank full (yes or no)
12. FWF Duration
–
FWF duration time (HH:mm:ss)
13. FWF Interval
–
FWF interval time (HH:mm:ss)
14. PassiveUVoff
–
Time from leaving fresh water production to turning UV off (HH:mm:ss)
15. UV off delay
–
Time from UV on to diversion valve to tank (HH:mm:ss)
16. AutoStart Tank
–
Autostart on tank empty (yes or no)
17. BP Delay
–
Time from feed pump to high pressure pump/R.O. BOOST (HH:mm:ss)
18. Salinity Level
–
Salinity error level (ppm)
19. Min Pressure
–
minimum pressure (Bar or PSI)
20. Min Pressure Time
–
Min pressure measure time (HH:mm:ss)
21. Max Pressure
–
Maximum pressure (Bar or PSI)
22. Sol. Valve Time
–
Solenoid valve time (seconds)
Configuration (Read) Menu
This menu monitors a selected list of configuration parameters, which may be of interest to the operator (e.g.
units are metric or US, FWF time interval, etc.). This menu is appended to the Display Menu.
1. Unit
–
units (metric or US)
2. Low Pressure 1 Inst
–
S1 Lo pressure sensor installed (yes or no)
4
3
System Daily Operation