Sea-doo SEASCOOTER SD5542, User Manual, Page: 8 / 16

Getting Started Battery Use
When you buy the SEA-DOO ® SEASCOOTER
™
DOLPHIN /
AQUA RANGER the battery is disconnected and needs to
be charged. Follow the safety cautions on pages 11, 12, 13
and 14 and charging instructions on pages 15, 16 and 17.
Using the SEASCOOTER
™
for swimming and
snorkeling.
To use the SEASCOOTER
™
for swimming or snorkeling
follow these instructions.
1. Charge the battery and install just before use.
2. Place the SEA-DOO
® SEASCOOTER
™
DOLPHIN / AQUA
RANGER into the water.
3. When ready to set off, switch the Safety Lock to the On
position shown in fig. 5a.
4. Pull and hold both Triggers to start the Propeller. (There is
a short delay before the Propeller begins to rotate).
5. To stop the Propeller, simply release one or both triggers.
6. Always set the Safety Lock to the Off position when out of
the water - see fig. 5b.
7. ALWAYS remove the battery when not in use.
11 10
Fig.5b Fig.5a
On Position
Off Position
For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2. Always ensure that the SEA-DOO ® SEASCOOTER
™
Dolphin / Aqua Ranger is out of the water, dry and placed
in a dry area.
15. Replace the Nose Cone and close the latches.
3. Pull the latches down and remove the Nose Cone as
shown in fig. 6.
4. Allow two minutes for any gasses to dissipate.
5.
Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 7.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13. When ready for use, place the battery into the housing
and connect the housing cable.
14. Make sure the seal and sealing surfaces are clean and
lubricated before replacing the Nose Cone. See fig. 8.
RE-CHARGE THE BATTERY
3
3
AT LEAST
MONTHS
EVERY
MONTHS
WARNING
BATTERY SAFETY
• Must remove and store the
battery separately from the unit
when not in use!
• Must re-charge the battery after
use WITHIN 24 HOURS.
• Must re-charge the battery at
least EVERY THREE MONTHS
when not in use.
User Manual must be read and
understood before use.
Please read and follow the
Battery Safety Instruction.
Incorrect battery maintenance
may reduce the battery life and
influence its function.
www.seadooseascooter.com
Important Notice: This machine is not to use to mix or to
work with sand, concrete and material with similar
physical characteristics. This machine is only to use for
swimming and diving in water.
Warning!
• The seascooter is designed for 1 person use.
• The seascooter is not a life saving device. Do not use it as
a buoyancy aid.