For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2.
Always ensure that the SEA-DOO
®
SEASCOOTER
™
Dolphin / Aqua Ranger is out of the water, dry and placed
in a dry area.
15. Replace the Nose Cone and close the latches.
3.
Pull the latches down and remove the Nose Cone as
shown in fig. 6.
4. Allow two minutes for any gasses to dissipate.
5.
Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 7.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13.
When ready for use, place the battery into the housing
and connect the housing cable.
14. Make sure the seal and sealing surfaces are clean and
lubricated before replacing the Nose Cone. See fig. 8.
STEP 1
STEP 2
Fig.4a
Fig.4b
8
9
1. Unlock two latches and remove Nose
Cone.
2. Rubber seal must be fitted as shown and
lightly lubricated with the supplied grease.
AQUA RANGER