Trouble Shooting
21
20
For battery charging follow these instructions.
1. Always ensure that the Safety Lock in the Off position is
Off - see fig. 5b.
2.
Always ensure that the SEA-DOO
®
SEASCOOTER
™
Dolphin / Aqua Ranger is out of the water, dry and placed
in a dry area.
15. Replace the Nose Cone and close the latches.
3.
Pull the latches down and remove the Nose Cone as
shown in fig. 6.
4. Allow two minutes for any gasses to dissipate.
5.
Disconnect the battery cable from the housing cable
(if not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in fig. 7.
6. Remove battery and place on a level surface.
7. Connect the battery cable to the charger cable.
8. Plug charger into mains, and turn on the supply.
9. Charging will take 14-16 hours for a fully discharged
battery. When the battery is charging the red LED is lit,
when the battery is charged the green LED is lit.
10. Disconnect the Charger from the mains.
11. Unplug the battery cable from the charger cable.
12. Allow battery to stand for 30 minutes before using it.
13.
When ready for use, place the battery into the housing
and connect the housing cable.
14. Make sure the seal and sealing surfaces are clean and
lubricated before replacing the Nose Cone. See fig. 8.
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the Safety Lock is in the "Off" position.
3. Disconnect and remove the battery - see page 15, step1-6.
4. Unscrew the eight Rear Grille screws as shown in fig. 11.
Unit does not function
If the motor does not start when both triggers are pressed,
make sure:
1. The battery is properly connected
2. The battery is fully charged
(see page 15, charging the battery)
3. The Safety Lock is in the "On" position
(see fig 5a, page 10)
4. There is no water in the battery compartment
(see page 23, accidental flooding)
Blocked Propeller
If the Propeller becomes blocked the Rear Grille and
Propeller can be removed, to remove the obstacle.
Removing rear grille and Propeller to remove obstruction
5. Whilst holding the Propeller, use an M6 socket to
remove the nut from the Propeller shaft (See fig. 12).
9. Replace the washer and nut and tighten with the socket
whilst holding the Propeller making sure it is securely
fastened (See fig. 14).
10. Replace the Rear Grille
11.
Replace the battery and connect and replace the Nose
Cone.
6. Slide the Propeller off the shaft, taking care not to loose
the drive pin or washers.
7. Remove the blockage from the Propeller.
8. Replace the drive pin (if removed), see fig. 13, and
Propeller. Turn the Propeller slowly until you locate the
pin and push the Propeller fully on.
Fig.11
Fig.12
Warning!
Crushing / Cutting Hazard
Before opening the grille for maintenance purpose, make
sure the master switch is in off position, and the battery is
disconnected.