Charging the battery
For battery charging follow these instructions.
1. Always ensure that the Master Switch is Off -
see figure 3.
2. Always ensure that the SEA-DOO
®
SEASCOOTER™
is out of the water, dry and placed in a dry area.
3. Give a half turn to the Latches and remove them from
the Nose Cone as shown in figure 5.
4. Remove the Outer Nose Cone and Buoyancy Control
Chamber.
5. Open the Vent by unscrewing the Vent Plug.
6. Remove the Inner Nose Cone. To do this, first feed the
silicone ring (provided with this manual) through the
latch holes in the Inner Nose Cone and pull over the
hooks on the Battery Housing (see figure 7). Then
screw the Pump Nozzle onto the Vent Hole and pump
air into the Battery Chamber until the Inner Nose Cone
pops off and then remove the silicone ring.
7. Allow two minutes for any gases to dissipate.
8. Disconnect the battery cable from the housing cable (if
not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER™) by
pressing the locking feature, as shown in figure 8.
9. Remove the battery and place on a level surface.
10. Connect the battery cable to the charger cable.
11. Plug charger into mains, and turn on the supply.
12.
SEASCOOTER PRO
- Charging will take 4 to 6 hours
for a fully discharged battery.
SEASCOOTER GTI / VS SUPERCHARGED PLUS /
GTS
- Charging will take 6 to 8 hours for a fully
discharged battery.
When the battery is charging the red LED is lit, when
the battery is charged the green LED is lit.
13. Disconnect the charger from the electrical plug/socket.
14. Allow battery to stand for 30 minutes before using it.
Important Notice: Keep the silicone ring permanently (Refer
to Page 2 and 3, Parts Diagram).Removing the inner nose
cone without the silicone ring is dangerous
17
16
Fig.7
Press here to release and pull to disconnect
Fig.8
Warning!
Replace the battery immediately if it is damaged.
