STORAGE
Leave all compartments open to air dry.
Engine Internal
Lubrication
NOTE:
The following must be per-
formed on each engine.
Connect a garden hose to cool the
exhaust system as explained in
EX-
HAUST SYSTEM FLUSHING
above.
Bring engine(s) to normal operating
temperature.
NOTICE
Properly follow the in-
structions given in the
EXHAUST
SYSTEM FLUSHING
procedure.
Close the water tap,
then
stop the en-
gine.
Open the engine compartment lid.
Remove storage tray.
Remove dipstick.
Remove engine cover.
Reinstall dipstick.
Disconnect ignition coil connectors.
WARNING
When disconnecting
coil from
spark plug, always disconnect coil
from main harness first. Never
check for engine ignition spark
from an open coil and/or spark
plug in the engine compartment
as spark may cause fuel vapor to
ignite.
IMPORTANT:
Never cut the locking
ties of ignition coil connectors. This
would allow mixing the wires between
cylinders.
Remove ignition coils.
NOTICE
Ensure there is no dirt in
coil holes before removing the spark
plugs. Otherwise, dirt would fall
into cylinder and will damage the in-
ternal components.
Remove spark plugs.
NOTE:
After
loosening
the
spark
plugs, a coil may be used to remove
the spark plugs. Simply bring the coil
down to spark plug and “hook” it to
then extract spark plug.
smr2006-016-030_a
1. Ignition coil
2. Spark plug
Spray XP-S Lube (P/N 293 600 016) or
equivalent, into spark plug holes.
To prevent fuel to be injected and also
cut the ignition at the engine cranking,
proceed as follows.
From the engine compartment, have a
second person hold throttle bell crank
in fully opened position.
F13G02Y
1
TYPICAL
1. Fully-opened position
Crank each engine a few turns to dis-
tribute the oil on cylinder wall.
98
______________
Summary of Contents for Islandia SE
