Sea-doo GTI 130 2022, Operator'S Manual

Page: 128 / 202

126
M Mo od de ellss w wiitth h 2 23 30 0 E En ng giin ne ess
It is important to expel any trapped
water that may have accumulated
from condensation in the intercooler.
Proceed as follows:
1. Lift seat.
2. Ensure there is an alignment line
drawn on the intercooler inlet
hose. This will ensure the hose is
not
twisted or kinked on
reinstallation.
3. Loosen the clamp retaining the in-
tercooler inlet hose.
4. Remove the intercooler inlet hose
from the intercooler.
N NO OT TE E::
This hose feeds the hot, compressed
air from the engine supercharger to
the intercooler inlet.
1. Hose alignment lines
2. Hose clamp
3. Intercooler inlet hose
5. The intercooler air side is self--
draining into the intercooler inlet--
side manifold. By disconnecting
the intercooler inlet hose, the pres-
ence of condensated water can be
visually assessed and properly
drained off without the engine
running.
6. Reinstall the intercooler air outlet
hose, ensure it is properly aligned
as prior to removal to ensure prop-
er engine operation.
E Exxh ha au usstt S Syysstte em m D Drra aiin niin ng g
In areas where temperature may
freeze, water trapped in the exhaust
system
and intercooler must be
removed.
Using the flushing connector, inject
pressurized air at 379 kPa (55 lbf/in²)
into system until there is no more
water flowing from jet pump.
1. Flushing connector
The following hose can be fabricated
to ease draining procedure.
T TY YP PIIC CA AL L
1. Flushing connector adapter
2. Hose 12.7 mm (1/2 in)
3. Air hose male adapter
N NO OT TIIC CE E
F Fa aiillu urre e tto o d drra aiin n tth he e e exxh ha au usstt ssyyss--
tte em m m ma ayy cca au usse e sse evve erre e d da am ma ag ge e tto o
tth he e e exxh ha au usstt m ma an niiffo olld d..
Remove special tools.
E En ng giin ne e IIn ntte errn na all L Lu ub brriicca attiio on n
1. Remove the seat(s).
2. Remove spark plugs. Refer to
Maintenance Procedures section.
3. By the spark plug holes, lubricate
each cylinder.
STORAGE