Sea-doo GTI 130 2022, Operator'S Manual, Page: 101 / 202

99
A Accttiivva attiin ng g S Sp po orrtt M Mo od de e
To activate the Sport mode, press
once on the MODE button while in
DEFAULT riding mode. The sport icon
will start to flash and a safety mes-
sage will scroll. For safety reason, fol-
low the instruction in the safety
message to activate the sport mode.
Once activated, the SPORT icon will
turn ON.
D De ea accttiivva attiin ng g S Sp po orrtt M Mo od de e
A single press on MODE button will
take you to the ECO mode.
E EC CO O M Mo od de e
((F Fu ue ell E Ecco on no om myy M Mo od de e))
ECO mode provides a smoother throt-
tle application and increased fuel
economy.
S Sp pe ee ed d C Co on nttrro oll M Mo od de ess ((IIff
E Eq qu uiip pp pe ed d))
To enter one of the speed control
modes, press SPEED CTRL button.
Depending
of the speed of the
watercraft, only one of the following
modes will be activated.
Once the desired mode is activated,
press the SPEED CTRL button then
change the value with the UP or
DOWN arrow button while the S
SE ET T
L LE EV VE EL L or S SE ET T S SP PE EE ED D message is
active.
To exit the selected speed control
mode, press MODE button or long
press SPEED CTRL button.
S Sp pe ee ed d L Liim miitte err M Mo od de e
Speed limiter mode is a function of
iTC (intelligent Throttle Control) sys-
tem that allows the operator to set the
desired maximum watercraft speed.
This is useful when cruising for long
distances, operating in limited speed
zones, or towing a tuber, skier or wake
boarder.
The operator must keep the throttle
depressed to maintain forward speed.
Once the maximum speed is set, the
operator
can vary the watercraft
speed from idle speed up to the set
speed using the throttle lever. The set
speed will not be exceeded even if the
throttle lever is fully depressed.
As you proceed under a constant
speed setting, keep your attention
level up to maintain good situational
awareness.
Slowing down is a matter of releasing
the throttle lever further than the set
point, or by pulling the iBR lever in.
If the iBR lever is pulled in for braking,
Speed Limiter mode is overridden but
n
no ott d de ea accttiivva atte ed d.
Once the iBR lever is released and
the throttle is pulled in to engage for-
ward thrust, the speed limiter function
will reengage to limit the watercraft
speed as it was set before.
P Prre erre eq qu uiissiitte e ffo orr S Sp pe ee ed d L Liim miitte err
M Mo od de e A Accttiivva attiio on n
Speed limiter MODE can be activated
when the watercraft is going at more
then 15 km/h (9 MPH).
OPERATING MODES