43
CAUTION:
Never flush a hot engine.
Always start the engine before open-
ing the water tap. Open water tap
immediately after engine is started
to prevent overheating.
Run the engine about 3 minutes at a
fast idle around 3500 RPM.
CAUTION:
Never run engine longer
than 5 minutes. Drive line seal has
no cooling when craft is out of water.
Lubrication
Spray BOMBARDIER LUBE lubricant
or equivalent, through hole of air intake
silencer keeping engine at fast idle
during one minute.
TYPICAL
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
NOTE:
After approximately half a
minute, close fuel valve to run engine
out of fuel while lubricating.
CAUTION:
When engine begins to
run irregularly because of fuel star-
vation, immediately stop water flow
before engine dies.
Close the water tap then stop the en-
gine.
Final Steps
Disconnect the garden hose.
Remove spark plug cables and con-
nect them on the grounding device.
Remove both spark plugs and spray
BOMBARDIER LUBE lubricant or
equivalent into each cylinder.
Crank the engine a few turns to distrib-
ute the oil on cylinder wall.
Apply anti-seize lubricant on spark plug
threads then reinstall them.
Properly reconnect spark plug cables
to spark plugs.
Wipe up any residual water from the en-
gine.
TYPICAL
1. Grounding device
Anticorrosion Treatment
To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such as
BOMBARDIER LUBE lubricant or
equivalent over metallic components
in engine compartment.
Apply dielectric grease (salt water re-
sistant) on battery posts and cable
connectors.
CAUTION:
Never leave rags or tools
in the engine compartment or in the
bilge.
F06F0CY
1
2
WARNING
Always use spark p lug cable
grounding device when removing
spark plugs.
F07H07Y
1
Smo2001-001a.book Page 43 Tuesday, May 23, 2000 2:18 PM
www.SeaDooManuals.net
Summary of Contents for 2001 LRV
Page 1: ...www SeaDooManuals net ...
Page 68: ...www SeaDooManuals net ...
