E-14
This model comes equipped with a strobe
bulkhead (black:
1
) and a TTL converter
bulkhead (red:
2
).
CAUTION
If you connect the YS series strobe sync
cord to the bulkhead for TTL converter (red:
2
), it could damage the pins on the bulkhead connector; so make sure never
to do that. Likewise, if you connect the TTL converter’s camera connection
cable to the strobe bulkhead (black:
1
), it could damage the pins on the
bulkhead connector; so make sure never to do that.
1
Remove the housing’s bulkhead connector cap
2
Make sure there are no scratches or
debris on the O-ring of the sync cord
being connected
3
Align the round mark (the notch) of
the sync cord with the round mark
(the convex part) of the strobe
bulkhead, and then push it straight in
4
Align the B part of the sync cord with
the screws of the strobe bulkhead,
and then rotate it until it stops
5
Rotate the C part of the sync cord until
it stops
z
Tighten it securely.
z
When removing the sync cord, loosen C
first, then B, and then pull the sync cord straight out holding onto A. Do not
pull on the cord part.
CAUTION
z
After use underwater, make sure to prevent water droplets from dripping
into the bulkhead connector by wiping moisture away from the bulkhead
connector and then turning the housing upside down and extracting the
sync cord. In the event that water droplets do drip into the connector,
promptly wipe away all moisture.
z
If you use incompatible strobes, not only might they not work correctly, but
they may also cause the camera and the strobe to malfunction.
Connecting the Strobe
1
2
Sync cord
Strobe bulkhead
A
B
C
