+44 (0)1543 443060
www.secontrols.com
Please keep these operating instructions for future reference and maintenance.
Subject to technical modifi cations. Diagram is not binding.
For further application, please contact SE Controls.
The actuator compiles with current safety directives.
Operating safety can be guaranteed only if installers comply
with the safety regulations in force in the country where the
actuator is used.
The actuator is not a structural member of the window.
Always mount the safety arms in bottom-hung applications.
The position of the three-way switch button must be
outside the fi eld of action of the moving part of the window.
Do not allow children to play with the fi xed or remote
controls.
When using the actuator, follow these safety
instructions described herein. This equipment
is designed for the automatic opening and
closing of the stated types of windows.
Do not install two or more actuators on the
same window without using a synchronisation
accessory.
Any other application of the actuator must
be approved after technical testing of the
application. Use only original accessories or
accessories approved by SE Controls to install
the actuator.
When opening or closing the window, make
sure other people are far away from the moving
part, even when a fi re detection system is
closing an open window.
1.4 Application and Use
It would be beyond the scope of these safety instructions
to list all the valid regulations and guidelines.
Always make sure that your system
corresponds to the valid regulations. Pay
particular attention to: the aperture cross-
section of the window, the opening time and
opening speed, the temperature resistance of
the cables and equipment, cross-sections of
the cables in relation to the cable lengths and
power consumption.
Care must be taken to ensure that actuator
products are controlled with compatible
products; refer to SE Controls. No liability will
be accepted and no guarantee nor service is
granted if actuator controls are used without
such compatibility being confi rmed.
Installation of this equipment must only be carried out by
authorised, competent and safety conscious persons.
Routing of cables and electrical connections only to be
done by a qualifi ed electrician.
The cables must be installed in such a way that they cannot
be severed off , twisted or bent off during operation.
Junction boxes must be accessible for maintenance work.
1.5 Installation
The actuator must be assembled and
connected only by specialised staff who have
been properly trained and who are familiar
with the problems associated with automatic
window opening and closing systems, technical
reference standards and safety standards.
The window closes automatically. When
opening and closing, the drive unit is stopped
by the power cut- off . The corresponding
pressure force is listed in the technical data.
Take care - the pressure force is high enough to
cause injury!
During assembly and operation do not obstruct
the window opening!
Danger of crushing/trapping!
Warning! Incorrect installation may render the
actuator dangerous! Follow all the instructions
set out below and the instructions applied to
the motor.
Power supply leads 230 V AC to be fused
separately by the customer. Keep power supply
leads sheathed until the mains terminal.
All low voltage cables (24 V DC) to be installed
separately from high voltage cables. Flexible
cables should not be plastered in. Provide
strain relief for freely suspended cables.
Adhere to the type of cables, cable lengths
and cross- sections as stated in the technical
information.
After installation and any changes to the system check all
functions by a trial run.
