中文
EN
D
LCD PL
ATE AMPLIFIER
43
42
BYPASS USER EQ
Back
Bypass a l l +
Enable a l l
Figure 35.
Bypass User EQ menu.
DSP SETTINGS > BYPASS USER EQ
In order compare the response of the subwoofer with and without the applied EQ, this section allows to
bypass all user EQs with a single click.
Remember that user EQs are bypassed by default and can be activated individually.
DSP SETTINGS > DELAY
The
Delay
section allows the user to apply a delay to the signal, visualize it in different units and determine
the total delay. This screen has the following three sections:
-
User added delay
: This is the delay defined or added by the user depending on the specific needs of
his application.
-
Preset delay: Depending on the preset enabled or selected, the system may include an additional
delay. This delay is added by the current preset and for some factory presets, it can be also edited.
-
Total DSP delay: Total sum of "User", "Preset" and internal DSP latency. It is not an editable parameter
and is only shown for information and reference.
The "
User
" and "
Preset
" delays can be defined in three different units, corresponding to the editable
parameters in the first two delay sections:
-
Samples
: for 48 kHz sampling rate.
-
Time
: Delay in milliseconds (ms), referred to the 48 kHz sampling rate.
-
Distance
: Delay in meters (m), referred to
c
= 343 m/s.
When changing a parameter in any section, all the other parameters are updated with the corresponding
value in their units.
Figure 36.
Delay menu.
DELAY
Back
User added delay:
> Bypass: OFF
Samples: 0
Time: 0.00 ms
Distance: 0.00 m
Preset delay:
Bypass: OFF:
Samples: 10
Time: 0.21 ms
Distance: 0.07 m
Total DSP delay:
Samples: 63
Time: 1.31 ms
Distance: 0.45 m
The table below details the minimum "
User
" delay available for the three subwoofers.
Depending on the preset, slightly higher delays can be defined.
Minimum "User" delay available
Subwoofer
Samples
Time [ms]
Distance [m]
S12 PRO
1285
26.8
9.2
S15 PRO
1250
26.0
8.9
M-F3A FS
1399
29.1
10.0
DSP SETTINGS > RESET USER PARAMS
The
Reset User Params
submenu allows to reset user DSP settings such as:
-
High-pass filter
-
Low-pass filter
-
Equalizers
-
Delay
-
Phase Inversion
-
Bypass user EQ
The Output Gain and the Preset selected are not affected by this function.
