中文
EN
D
RIGGING AND INS
TALL
ATION
21
20
RIGGING AND INSTALLATION
RIGGING COMPONENTS
M-F3A PRO
This product features the following rigging elements:
-
Front rigging points: aluminum bars on both sides for frontal fixing, including one security pin each.
-
Rear rigging piece: steel tracks for splay angle definition with one security pin and an unfolding bar for
rear connection. The available holes allow for defining the tilt of the specific unit in combination with
the previous element.
Since the moving piece of the last unit in an array is not used, it must be locked by inserting
the security pin in the "Stow" position.
-
Security pins: 6-mm ball lock pins in stainless steel for safe locking between units.
To lock and unlock them properly:
1. Push and hold the button to release the blocking ball.
2. Insert the pin through the pieces to link.
3. Release the button to close the mechanism. Pull the pin outwards to verify a close and
safe connection.
S12 PRO AND S15 PRO
This product features the following rigging elements:
-
Top holes and bottom rubber feet: included to indicate the correct position, assuring a firm grip
when stacking S12 PRO or S15 PRO subwoofers.
-
Side locking points: Male lever on the top of the cabinet and the female receptacle on the bottom.
These must be locked when S12 PRO or S15 PRO subwoofers are used in stacked systems as described
below and shown in figure 7:
1. Pull the handle to release the blocking piece.
2. Move the lever upwards to the receptacle of the unit above.
3. Release the handle to close the mechanism. Try to move the lever downwards to verify a close
and safe link.
Figure 5.
Front and rear rigging pieces of the M-F3A PRO units.
Figure 7.
Linking system for stacks in S12 PRO and S15 PRO subwoofers.
Figure 6.
Manipulation of the security pins in the M-Line products.
1
3
2
Stack
Snap
3
2
1
