3.1. Connection of current modulator
Work on the connection of the modulator must be carried out with the accumulator
switched off.
Before starting the installation, select a location for installation of the modulator.
The modulator must be installed in a place protected from excessive heat and moisture. It
is preferably to be nearby the accumulator.
After fixing the modulator, connect the wire of electrolyzer to its terminal block (see. Fig.
3.3., 3.4.).
On the electrolyzer install the temperature sensor, which is designed as a terminal for
fastening with the screw M8 (supplied optionally).
Connection scheme of the modulator is shown in Fig. 3.2. Note that the 12V supply (or
24V) is preferable to take from the terminals of the car’s electrical generator.
Installation on injection engine
Connect the blue wire from the modulator to the signal wire of fuel nozzle. The black wire
should be connected from terminal of modulator “Power –” to the car body.
A fuse wire from the terminal “Power
+
” should be connected to the terminal “+” of
electric generator or accumulator (see. Fig. 3.2, 3.3.).
Fig. 3.2. Connection scheme of the modulator to the electrolyzer with a single wire.
(standard set)
Fig. 3.3.
Connection scheme of the modulator to the electrolyzer with two wires
.
