Operation & Maintenance Manual
──
LG936 Wheel Loader
37
8.19 Maintenance and Storage of Tire
8.19.1 Maintenance of Tire
z
The Explosion of tire can push the parts, such as tire, rim, driving axle and etc., as far as 500m or
more. The explosion and the particles can lead to sever hurt and death, so please keep the
pressure of tire at the normal level. Inflation pressure should not surpass the stand value. The
inflation pressure please refer to
“
CHAPTER II - 8 TECHNICAL PERFORMANCE
& PARAMETER
”
z
The temperature raising caused by high speed driving may lead to increasing of the pressure of
tire, which is the normal phenomenon.
Never
try to reduce the pressure, but reduce the speed to
cool the tire. The tire may explode if continuously driving in high speed that can lead the tire over
heat.
z
Stand at the back of the tire and try to stand as far as possible away from the tire when adjust the
pressure of tire.
z
Check the tire, rim every day whether the tire is crack or bubble.
Never
operate at low pressure
condition.
z
Check the bolt and nut of rim whether there is lost. Check whether the torque of nut satisfy the
suggest value of the factory.
z
Never
enter the front or rear place of the rolling direction of tire. Check the tire from side.
Forelock the other tires if disassembles one tire.
z
Pay attention when weld near the tire which can cause the tire explode.
z
Only the person trained with professional license can repair the tire and rim using specific tool
and following the proper steps. Otherwise it is very dangerous.
z
Use the uniform tire with the same standard and same flower pattern to replace.
8.19.2 Storage of Tire
z
It is the basic rule that the tire should be stored in warehouse. No
one can enter without permission. Set fence around and hang the
notice of “
No Enter
” if it is necessary to store the tire outside the
warehouse.
z
Store the tire at dry and clean place. Water can help oxide the tire,
