Operation & Maintenance Manual
──
LG918 Wheel Loader
58
When this button is pushed down, all the turning lamps will blink for an emergency circumstance,
sending light to warn the other vehicles and passersby. Press the button once again and the button
springs back, so all the turning lamps will stop blinking.
z
Rear Light Lamp Switch:
Press bottom side, the rear light lamp and the front and rear side-indicator lamps will come on;
press top side, the lamps will go off.
z
Rear Headlight Switch:
Press bottom side, and low beam of the rear headlight on the engine hood will come on;
Press top side, and the high beam of the rear headlight on the engine hood will come on.
If no side is pressed, no lamp will come on.
z
Top Lamp Switch:
This switch is behind the ceiling lamp in the operator cab (see picture).
Press ON position to turn it on.
Press OFF position to turn it off.
Notice: Turn it off during driving.
z
Fan Switch:
Press the bottom side for low air speed;
Press the top side for high air speed;
Press the middle of the button, and the fan will stop.
z
Horn Switch:
Press the button in the middle of the steering wheel, and the horn will sound.
z
Radio and CD Player Control Panel(if assembled)
This switch is at the right side of the ceiling cab, and for the details please refers to
Radio and
CD player Assembly & Operation Manual
.
1.2.3 Steering Wheel
The steering wheel and steering unit are connected. Turning the steering wheel clockwise, the
machine turns right; turning the steering wheel counter-clockwise, the machine turns left.
The features are listed below:
z
The rotation angles of the steering wheel and the machine are not equal. If the steering wheel is
continuously turned; the machine rotation angle will increase until at the needed position.
z
The faster the steering wheel turns, the faster the machine turns.
z
The steering wheel will not automatically come back after turning, the turning angle of the
machine will be kept. After finishing turning the machine, turn the steering wheel in the reverse
direction to keep the machine moving in a straight direction.
