PROGRAMMING SYSTEM SETUP (Continued)
Keypad Status after Step Completition
Configuring 3rd Relay (Default: CCTV 30 Sec)
A) Enter 6 #
B) Select one of the following:
Doorbell (1 second output)
I. Enter 1 #
CCTV / External Light
I. Enter 2 #
II. Enter the desired On Time in two digits (01-99 seconds),
followed by #
2
nd
Auxiliary Device
I. Enter 3 #
II. Enter the desired momentary output time in two digits (01-99 seconds) followed by #
-- or --
Enter 0 0 to set the auxiliary device for Manual Operation (ON/OFF), followed by #
C) Return to Step 3 or enter to exit programming.
Examples: 6 # 1 # Set Doorbell Option
6 # 2 # 2 5 # Set CCTV/Light with a 25 second On Time
6 # 3 # 0 0 # Set Auxiliary Device with Manual Operation
Step
A)
i.
ii.
Beep
Double
Double
Triple
Red LED
Slow Flash
Slow Flash
Slow Flash
Green LED
Slow Flash
Fast Flash
Solid
Automatic Line Feed (Default: ON)
A) Enter 7 #
B) Enter 0 # to turn OFF
-- or --
Enter 1 # to turn ON
C) Return to Step 3 or enter to exit programming.
Note:
The printer line feed setting should only be adjusted if you encounter printer problems
(i.e. An unnecessary extra line or printing on the same line).
Step
A)
B)
Beep
Double
Triple
Red LED
Slow Flash
Slow Flash
Green LED
Slow Flash
Solid
Daylight Savings Time “DST” (Default: ON)
A) Enter 8 #
B) Enter 0 # to turn OFF
-- or --
Enter 1 # to turn ON
C) Return to Step 3 or enter to exit programming.
4. To Print System Setup, enter 9 #
5. Enter
to complete programming sequence and reset the system to normal operation.
P:\INSTALLATION INST\ACCESS CONTROL\INST-935.vsd 0505 Page 15
**
**
**
**