PROGRAMMING SYSTEM SETUP
The 935 EntryCheck
™
System Setup can only be modified if you know
the Master Code. When the system is initially setup, the default
system settings should be reviewed prior to other programming.
1.
Enter
*
3
2.
Enter the Master Code followed by #
Example: 3 123 #
This opens programming and causes
3.
Proceed to one of the following options which requires programming:
To Change the Master Code (Default: 1,2,3)
A) Enter 1#
B) Enter the New Master Code
followed by #
C) Re-enter the New Master Code, followed by #
D) Return to Step 3 or enter to exit programming.
Note:
If you forget the Master Code, locate the control module. (The control module is typically
installed in a secured area within 15’ of the keypad.) Remove the cover, locate and press
the “PGM SW” switch on the circuit board for 3 seconds (make sure the 5 dip switches are
OFF). This will take you to Step 3 of Programming System Setup. Once you press the
program switch, you have 1 minute to begin the program sequence.
Setting the Door Open Time (Default: 5 Seconds)
A) Enter 2 #
B) Enter the desired Door Open
Time in two digits (01 to 99 seconds), followed by #
Example: 2 # 1 5 # Set a 15 second Door Open Time
C) Return to Step 3 or enter to exit programming.
Red LED Green LED
Slow Flash Solid
Keypad Status after Step Completion
Setting Latching Option (Default: Off)
A) Enter 3 #
B) Select desired latching option
Off Enter 9900, followed by #
Manual Enter 9901, followed by #
Timed Enter the desired time (hour/minute) in four
digits (24 hour), followed by #
Example: 3 # 1 7 0 0 # Sets timed latching at 5:00 p.m.
C) Return to Step 3 or enter to exit programming.
P:\INSTALLATION INST\ACCESS CONTROL\INST-935.vsd 0505 Page 13
*
*
**
**
Step
A)
B)
Beep
Double
Triple
Red LED
Slow Flash
Slow Flash
Green LED
Slow Flash
Solid
Step
A)
B)
Beep
Double
Triple
Red LED
Slow Flash
Slow Flash
Green LED
Slow Flash
Solid
**
Step
A)
B)
Beep
Double
Triple
Red LED
Slow Flash
Slow Flash
Green LED
Slow Flash
Solid
