Scytek electronic Galaxy 5000RS, Product Manual

Page: 19 / 36

Galaxy 5000RS - Page 15
Model: Galaxy 5000RS-M
1- Tach wire must be connected , The system must learn RPM.
2- Hand brake must be connected.
3- Door trigger must be connected
4- Clutch override installed
NOTE: MUST USE RELAY, SEE PAGE 26.
Remote Starting
With engine running and Hand-brake engaged put the vehicle transmission in neutral and remove the foot
from the brake pedal, press the remote start button on your transmitter, parking lights will flash twice
indicating Manual Start Mode is enabled, turn off the Ignition switch, the engine will remain running. Open
and close the door, the system will shut the engine Off. Using the remote Control, Arm/Lock the vehicle.
Vehicle is now ready for remote start operation.
Starter Ready Mode is canceled any time the door is opened; hand brake is released or any
other error condition.
To Remote Start the System:
1. Be sure the system is not in Valet Mode.
2. Press and hold Button 4 for three seconds.
· The parking lights will turn on.
· The LED will flash rapidly.
· The engine will start and run for the duration of its programmed Run Time.**
· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
**If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle
fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).
Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle.
Shut Down
When the the Remote Start feature is active, any of the following actions will shutdown the engine:
1. Pressing Button 4.
· After the engine shuts down the doors will lock (if installed).
2. Pressing the Brake Pedal.
3. Opening the Hood. (
safety switch must be installed)
4. Remote Start Time-Out (completion of the timed run cycle).
5. Emergency Brake Off.
Manual Transmission Remote Start Features