Comfort Harness - Assembly
Page 9
Step 6 - Installing the Crotch Strap
•
Install the remaining rubber piece
on the belt.
•
Lead the belt end upwards through
the horizontal slot at the bottom of
the backplate (from back to front).
•
Lead the belt end through the
rubber piece, through the backside
D-ring and back through the rubber
piece.
Adjust the harness to the diver, by pulling the left and right belt through the tri-glides on the
back.
Should the belt be too long, you may cut it to length. In this case, be sure to melt the cutted
belt edge with a lighter, in order to avoid fraying.
You may also fold back the overlapping belt end to the left and secure this end to the belt
with duct tape.
