TB-9071
Page 3 of
6
© 2016 DESCO INDUSTRIES, INC.
Employee Owned
Features and Components
Figure 4. Combo Tester features and components
A. 6-9VDC Power Jack:
Connect the
770034
or
770035
power adapter (sold separately) here to power
the Combo Tester.
B. Test Result LEDs:
Displays the test results.
C. Foot Plate Jack:
Connect the banana plug terminal
of the foot plate cord here and the other end to the
pedestal (
770031
).
D. Rocker Switch:
Toggle to the left when performing
a footwear test. Toggle to the right when performing a
wrist strap test.
E. Single-Wire Wrist Strap Jack:
Insert your
single-wire wrist cord here to test your wrist strap.
F. Test Switch:
Push down and hold your finger here
to perform a test.
G. Low Battery LED:
Illuminates when the battery
power is low and needs to be replaced.
Installation
The Combo Tester is portable when powered by a 9V
alkaline battery, but it also has the flexibility of being
permanently installed at a location. Use the three
keyhole slots located on the back of the Combo Tester
to mount it to a wall or stand.
INSTALLING THE
770030
COMBO TESTER
1. Install the 9V alkaline battery into the Combo
Tester.
2. Select a location to mount the Combo Tester.
3. Install three #6 or #8 screws into a wall or other
vertical surface as shown in the figure below. Make
sure that the screw heads do not project out more
than 1/4" from mounting surface.
Figure 5. Combo Tester keyhole slots
4. Mount the Combo Tester onto the screws, and pull
it down to secure it into place.
5. Set the Stainless Steel Foot Plate below the tester
(if applicable).
6.
Insert the 6' long foot plate cord’s banana plug into
the Combo Tester’
s foot plate jack.
Figure 6. Inserting the foot plate cord’s banana jack into
the Combo Tester
7. Snap the opposite end of the foot plate cord onto
the Stainless Steel Foot Plate.
Texas Technologies, Inc.
3600 W. Whitestone Blvd. Cedar Park, TX 78613
512.267.0100
–
https://www.texastechnologies.com/static-control-2/testers-meters/
–
G
F
D
E
C
A
B