EN ::: 9
Installation recommendations
Remember
there are specific standards that have to be strictly followed regarding
the safety rules of electrical installations and automatic gates and doors.
As for the legal requirements and standards that must be adhered to, please take
notice of the following points to ensure maximum safety and reliability of your
installation.
1. Before installing, check the surrounding environment. Carefully evaluate any
hazards which could be physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with persons’ bodies (insects, leaves, etc.), floo-
ding hazards, or any other exceptional events.
2. Check the main voltage numbers is the same as the numbers that are given on
the rating plate and in this manual.
3. Check and make sure if there is suitable electrical protection against short
circuits/power spikes and proper earthed on the main supply.
Remember
the unit having main voltage running through it (electrocution hazard,
fire hazard).
4. Take care with the control unit; the parts may be subject to damage if the
control unit is abused.
5. Make sure that you have all the necessary materials, and they are suitable for
this kind of use.
6. Read all the instructions thoroughly, and make sure they are understood before
attempting to install the opener.
7. Before starting the installation carefully analyze all the risks relating to automa-
ting the door. Verify that the door is automated in a sound condition and that
the mechanisms are in good working order. Observe the safety margins and
minimum distances.
8. Carefully evaluate the safety devices to be installed and the right place to install
them; always install an emergency stop device for power interruption to the
opener if it is required.
9. Once the risks have been analyzed, install the opener and relative safety
devices, emergency stop and/or photoelectric cells.
Important note:
As for additional safety rules, we strongly recommends the fitting of
Photo Electric safety beams on all installations.
10. While installing the opener, strictly follow all the instructions given in the instruc-
tion manual. If some points or procedures in this manual are not very clear,do
not install the unit until all doubts have been cleared up with our technical
department.
