Scout X10, Service Manual

Page: 35 / 80

Service manual - X10 35
Troubleshooting
Fault signal/problem Cause Solution
1 LED The battery needs charging
or there is a bad
connection to the battery. Check the battery
connections and recharge
the battery.
2 LEDs The left-hand motor (m1)
connection is not good. Check the connection and
the cabling.
3 LEDs The left-hand motor (m1)
has a short circuit
connection to the battery. Contract your supplier.
4 LEDs The right-hand motor (m2)
connection is not good. Check the connection and
the cabling.
5 LEDs The right-hand motor (m2)
has a short circuit
connection to the battery. Contact your supplier.
6 LEDs An external signal prevents
the wheelchair from driving. The external cause
depends on the type of
wheelchair, one possibility
is that the battery charger
is still connected.
7 LEDs Joystick fault. Make sure that the joystick
is in the center position and
re-try to switch on the
system.
8 LEDs Control system fault.
Check all connections and
cables.
9 LEDs The parking brakes have a
bad connection. Check the connections of
the parking brake and of
the motor.
10 LEDs An excessive voltage has
been applied to the control
system. This is usually
cause by a poor battery
connection. Check the battery
connections.
7 LEDs + Speed indicator Communication fault. Check the connection and
the condition of the joystick
cable.
8 LEDs + Actuator indicator Actuator trip If more than one actuator
is installed, check which
one in not working
correctly. Check the
actuator cabling.
Wheelchair moves slow or
slugglish Battery in poor condition Check the battery
Setting for maximum speed
is too low. Adjust the setting for
maximum speed.