PACKING LIST
Hedge Trimmer - Blade Cover - Owner’s Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
If any parts are damaged or missing, please call 1-800-618-7474 for
assistance.
UNPACKING
This product requires no assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
OPERATING
TO TURN THE TOOL ON
Push the lock button backward with your thumb and then squeeze
the trigger with your fingers. (Once the tool is running, you can
release the lock button). To turn the tool OFF, release the trigger.
CAUTION
: Blade coasts after turned off.
Do not use under wet conditions.
Do not store with switch locked on.
WARNING:
To guard against injury, observe the following:
Read owner’s manual before using,
Save owner’s manual.
Keep hands away from blades.
Keep hands on handles. Don’t overreach.
WARNING:
Do not allow familiarity with this type of product to make
you careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
EXTENSION CORD
- Always keep extension cord behind
trimmer and away from the trimming operation. Never
drape it over a hedge being trimmed. If you cut or damage
the cord, unplug it at the electrical outlet immediately,
before inspection or repairing the cord.
You may also place the extension cord in the cord retainer.
Form a loop in extension cord and push the loop through
the hole in the rear handle. Position the loop over the cord
retainer and pull back to secure. Connect power cord of
unit to extension cord.
ASSEMBLY
TRIMMING INSTRUCTIONS
2. LEVEL HEDGES—
To obtain exceptionally level hedges,
a piece of string can be stretched along the length of the
hedge as a guide.
CAUTION:
Do not use the trimmer for cutting stems
greater than 5/8”. Use the trimmer only for cutting normal
shrubbery found around houses and buildings.
3. TRIMMING NEW GROWTH—
A wide, sweeping motion,
feeding the blade teeth through the twigs is most effective.
A slight downward tilt of the blade in the direction of the
motion gives the best cutting.
1. WORKING POSITION–
Maintain proper footing and
balance and do not overreach. Wear safety goggles,
non--skid footwear and rubber gloves when trimming. Hold
the tool firmly in both hands and turn the tool ON. Always
hold the trimmer, as shown, with right hand on the switch
handle and left hand on the front. Never hold the tool by
the blade guard. Keep unit below waist level.
4.
SIDE-TRIMMING HEDGES—
Begin at the bottom and
sweep up
5
Model HT10020S
