11
•
Follow the appropriate regulations for shipment. Package batteries securely. Weight limits apply to batteries and to
batteries with equipment for passenger and/or cargo aircraft. Pursuant to 49 CFR 173.185, all shipments of hazardous
materials must comply with packaging regulations based on the recommendations made by the United Nations. There
can be substantial fines and penalties for non-compliance.
Desktop Charger use
1) Connect A/C adaptors 2.1mm plug into the charger base,
then connect to 110V AC wall outlet.
2) Upon power up, the charger’s LED status indicator flashes
from RED to YELLOW to GREEN and then turns OFF
The LED remains OFF when no battery is detected.
3) Insert the battery into the charger as illustrated and rotate
battery end cap 90 degrees clockwise to lock for charging.
Note: The battery can only be inserted one way into the
charger base because of the notch. Do not force the
battery into charger.
NOTE: IF THE LED CONTINUES FLASHING RED WHEN NO BATTERY IS INSTALLED,
THE CHARGER MAY NEED TO BE RESET OR MAY NEED SERVICING. UNPLUG THE
CHARGER, WAIT TWO MINUTES, THEN RECONNECT AND REPEAT.
Fast Attack Truck Charger use
CAUTION
Some power sources on vehicles are not active
all the time. Be sure that the power source
chosen will provide the necessary power for the
time required to recharge a battery. The
charging system will not recharge a battery if
the power source to the charger is not active.
Consult the vehicle manufacturer if you have
any questions about its available power sources
before installing the charging system.
1) Please refer to the Scott’s X-Series Fast Attack Truck Charger guide for mounting details.
2) Upon power up, the charger’s two (2) LED status indicators flash from RED to YELLOW to GREEN and then
turn OFF.
The LEDs remain OFF when no battery or X190 is detected.
3) Insert thermal imager into Fast Attack “U” shaped opening. The X190 should be placed into the FA with the
three (3) charging contacts aligned and the handle protruding thru the “U” shaped opening.
4) Ensure the latch is securely fastened prior to the apparatus moving.
5) Once the X190 is fastened securely, the (top) GREEN LED should begin flashing indicating the battery in the
X190 is charging. When fully charged the LED turns SOLID GREEN.
6) Insert the spare battery as shown in the charging port located in the lower right of the FA charger. Note:
That the notch at end of battery should be facing towards the camera. Ensure the battery locks into place by
rotating the battery end cap clockwise 90 degrees.
7) Once the spare battery is fastened securely, the (bottom) GREEN LED should begin flashing indicating the
spare battery is charging. When fully charged the LED turns SOLID GREEN.
8) Ensure spare battery is securely fastened prior to the truck moving.
NOTE: BOTH THE X190 AND THE SPARE BATTERY MAY BE CHARGED AT THE SAME TIME.
WARNING
FAILURE TO PROPERLY SECURE CAMERA AND BATTERY MAY RESULT IN SERIOUS INJURY OR DEATH.
Summary of Contents for X190
Page 2: ...2 ...
