Assembly Instructions
1. Begin the assembly of your AquaSweep dock mount model by removing the stainless-steel bolt from the
yoke assembly. Fig. 1
2. Adjust the gray AquaSweep housing to the desired angle for water flow, and secure in place with the
stainless-steel bolt. Fig. 1
3. The next step is to fasten the stainless-steel basket to the intake side of the gray AquaSweep housing.
This is easily done by aligning the 3 basket eyelets with the 3 pre-drilled holes on the housing and fastening
with the 3 small self-tapping screws provided. Fig. 2
4. Secure the dock plate to your wooden or metal dock, utilizing the 4 large self-tapping screws. Fig. 3
5. Once the dock plate has been secured, the stainless-steel pole of the oscillator can be inserted through the
dock plate sleeve. Simply loosen the 2 thumb screws from the dock plate sleeve, insert the pole from the
top through the sleeve adjusting to the desired height, and then re-tighten the 2 thumb screws. Fig. 3
6. Now, slide the yoke assembly over the bottom of the stainless-steel pole and secure with the bolt provided.
Fig. 3
7. The AquaSweep dock mount model easily adjusts for varying water levels by loosening the 2 thumb screws
from the dock plate and raising or lowering the AquaSweep assembly. Please note, the 2 thumb screws
are coated with a special lubricating compound specifically designed for stainless-steel to ensure proper
function. An extra packet of this compound has been included with your AquaSweep purchase; periodic
lubrication of the 2 thumb screws is required for years of problem free use and for warranty validation.
8. Finally, power can be supplied to your AquaSweep utilizing a standard 110 volt receptacle protected by
a GFCI. Extension cords should not be used for the Aquasweep. Run an extension cord to the Oscillator
assembly, connecting it to a plug protected by a GFCI. Disconnect power when swimmers are present.
Dock Plate
Yoke
Adjustment
Fig. 1
Fig. 3
18"
Fig. 2
Basket
Installation
