Assembly Instructions
1. Begin the assembly of your AquaSweep dock mount model by removing the stainless-steel bolt from the yoke
assembly. Adjust the gray AquaSweep housing to the desired angle for water flow and secure in place with the
stainless-steel bolt. Fig. 1
2. The next step is to fasten the stainless-steel basket to the intake side of the gray AquaSweep housing.
This is easily done by aligning the 3 basket eyelets with the 3 pre-drilled holes on the housing and fastening
with the 3 small self-tapping screws provided. Fig 2
3. Secure the dock mounting bracket to your wooden or metal dock, utilizing the 4 large self-tapping screws. Fig. 3
4. Once the dock mounting bracket has been secured, the stainless-steel pole can be inserted thru the dock mounting
bracket. Simply loosen the 2 thumb screws from the dock plate sleeve, insert the pole from the top thru the
sleeve by approximately 12 inches, and then retighten the 2 thumb screws. Fig. 4
The AquaSweep dock mount model easily adjusts for varying water levels by loosening the 2 thumb screws from the
dock mounting bracket and raising or lowering the AquaSweep. Please note, the 2 thumb screws are coated with a
special lubricating compound specifically designed for stainless-steel to ensure proper function. An extra packet of this
compound has been included with your AquaSweep purchase; periodic lubrication of the 2 thumb screws is
required for years of problem free use and for warranty validation.
5. Now, slide the yoke assembly over the bottom of the stainless-steel pole and secure with the bolt provided. Fig. 5
6. Finally, power can be supplied to your AquaSweep utilizing a standard 110 volt receptacle protected by a GFCI.
Extension cords should not be used. Disconnect power when swimmers are present.
Always use a GFCI
Always disconnect the power
when swimmers are present
!
Adjusting the position of the AquaSweep while in operation will cause
the dock plate thumb screws to strip, resulting in permanent damage
to the dock plate. Always disconnect power before adjusting the
AquaSweep, and keep the dock plate thumb screws lubricated.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
YOKE ASSEMBLY
DOCK
MOUNTING
BRACKET
12"
SS BASKET
!
Do NOT use an extension cord
to supply power to the motor
!
