Cleaning Interior - continued
8. Remove the two screws that hold the water pan in
place. Push down with one hand on the front of the
pan while pulling forward on the bottom back side.
9. Wash the interior components (cutter grid, exterior
of hoses, and water pan) and the storage bin, door
gasket, and ice scoop with mild soap or detergent
and warm water. Rinse in clean water. Then clean
the same parts with a solution of 1 tablespoon (15
mL) of household bleach in 1 gallon (3.8 L) warm
water. Rinse again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic
parts in dishwasher. They cannot withstand
temperatures above 145°F (63°C).
10. Replace water pan by pushing back on the
bottom with one hand while pushing up and back on
the top. Secure the water pan by replacing both
screws.
11. Check the following:
•
Drain cap from the water pan is in place.
•
Hose from water pan is inserted into storage bin
drain opening.
12. Slide the cutter grid back into place and secure it
by replacing the right-hand screw and plastic spacer.
Then tighten the left-hand screw. Reconnect the
cutter grid and ice level sensor harnesses.
Changing the Light Bulb
The ice maker has a light bulb in the top of the
storage bin.
To replace it, open the bin door and follow these
instructions:
1. Unplug ice maker or disconnect power.
2. Remove the three screws that hold the cutter grid
cover in place. Reach behind the control panel and
pull the light bulb down from the ceiling.
3. Replace with a 12-volt wedge base-type bulb
(automotive #917). Locate the light bulb receptacle in
the ceiling behind the control panel. Align the flat
edge of the light bulb with the receptacle and snap
the bulb into place.
4. Replace the cutter grid cover with three screws.
5. Plug in ice maker or reconnect power.
CSW45
July 1999
Page 15