Panel Removal
1.
Locate and loosen the two screws at the front
edge of the top panel.
2.
Pull the front panel out at the top until it
clears the top panel.
3.
Lift the front panel up and off the machine.
4.
Remove two screws from the front corners of
the top panel.
5.
Lift up the front of the top panel, push it back
an inch, then lift to remove.
6.
Locate and remove the screws holding each
side panel to the base.
7.
Pull the side panel forward to release it from
the back panel.
This manual covers several models. The model
number on the ice machine can be found either on
the dataplate, which is on the back panel, or the
serial number tag, which is behind the front panel.
See the illustration for the locations of the dataplate
and the serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on
the dataplate on the condenser near the quick
connect fittings.
Write the model and serial number of the ice
machine here:
Write the model and serial number of the remote
condenser here:
Write the model and serial number of the ice
storage bin here:
Write the day of initial start up here:
That
day starts the warranty period.
Uncrate and Set Up
Begin with the ice storage bin. Uncrate and attach
legs. Check the bin top gasket for tears or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Install the bin top adapter if one is required for the
application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Cut away
any shipping strapping. Lift the ice machine off the
skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift.
If lifting from the front, be sure that fork tines are
under the front and back of the cabinet. If lifting
from the side, be sure to have tines under the front
and back. Do not lift on the sump bottom.
Scotsman BH1100, BH1300, BH1600: Position
back of ice machine about 2 3/8" from back of
bin.
Secure the ice machine to the bin with the
hardware provided (two metal Z straps and four
bolts).
October 2010
Page 7
C2648
Remote Condenser Models - User Manual
6
1
5
Panel Removal
