liner, curtains and reservoir with the sanitizer
solution.
21. Thoroughly wash the shelf of the ice machine
cabinet where the reservoir was resting.
22. Thoroughly wash the interior of the evaporator
compartments including the back panels and
evaporator edges.
23. Return the reservoir to its original position
24. Return the sump cover, water level sensor,
water distributors with covers, pump hoses,
evaporator covers, right side panel liner and
curtains to their original positions on the ice
machine.
25. Return the pumps to their normal positions.
26. Pour one gallon of the sanitizer solution into
the reservoir.
27. Push and release the yellow Clean button.
28. Operate the machine for about a minute.
29. Push and release the yellow Clean button
again.
30. Operate the machine for 20 minutes then push
the red Off button.
31. Return all removed panels to their original
positions.
32. Push and release the green ON button to
resume ice making.Remove and discard all ice.
Clean Storage Bin
Mix a solution of Scotsman Nickel Safe ice
machine cleaner and wash all interior surfaces of
the ice storage bin to remove any mineral scale
build up. Pour excess cleaner solution into the bin’s
drain.
Mix a solution of sanitizer and thoroughly wash all
interior surfaces of the ice storage bin. Pour excess
sanitizer solution into the bin’s drain.
Water filters
If the machine has been connected to water filters,
check the cartridges for the date they were
replaced or for the pressure on the gauge. Change
cartridges if they’ve been installed more than x
months or if the pressure drops too much when the
ice machine fills with water.
October 2010
Page 21
C2648
Remote Condenser Models - User Manual
Remove Water Distributor
Squeeze Tabs Together, Slide Out Until it Stops,
Then Lift to Remove
Inspect Orifice Holes
Inspect Water Distributor
