1996-00 Chevrolet Express Van
Read pages 3-6
1996-00 GMC Savannah
for kit assembly.
RADIO REMOVAL:
1. Carefully pull out on
2171 RIGHT
BRACKET
dash
instrument/
2171
SOPORTE
LEFT
DERECHO
radio dash bezel to
BRACKET
USE HOLE #8
USE HOLE #8
2171
release spring clips,
SOPORTE
USA ABERTURA
USA ABERTURA
IZQUIERDA
unplug
connectors
NO. 8
NO. 8
and remove panel.
2171
USE HOLE #2
2. Compress the two plastic
USA ABERTURA NO. 2
side radio mounting clips,
slide radio out of dash, unplug connectors and remove radio.
USE HOLE #2
USA ABERTURA NO. 2
USE THE INDICATED BRACKETS AND HOLE LOCATIONS. SEE PAGE 4.
Usa los soportes y localizaciónes de aberturas indicadas. Vea la página 4.
Read pages 3-6
1995-99 Chevrolet Lumina
for kit assembly.
1995-99 Chevrolet Monte Carlo
RADIO REMOVAL:
"C1" BRACKET USE HOLE #2
"C1" SOPORTE USA ABERTURA NO. 3
"D1" BRACKET USE HOLE #2
"D1" SOPORTE USA ABERTURA NO. 2
1. Remove
the
four
T-15 TORX screws
from the driver’s
lower knee bolster.
2. Pull on the radio dash
bezel to release the
spring clips and remove.
3. Extract the two 7 mm
RIGHT SIDE
screws from the radio,
LADO
unplug and remove
LADO
LEFT SIDE
DERECHO
FRONT OF KIT
the
radio.
IZQUIERDA
FRENTE DE
ESTUCHE
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1990-94 Chevrolet Lumina
Read pages 3-6
RADIO REMOVAL:
for kit assembly.
1. Remove the two screws from the lower steering column trim piece
(below the column). Pull the panel down to access the bottom
portion of the dash trim.
2. Pull outward along the top and bottom portion of the trim panel. Release each vent's individual
spring
clip.
3. Extract the four screws from the radio bracket.
4. Pull the unit out of the cavity. Disconnect the connectors and remove the unit.
NOTES:
1. Due to its rear support, you might need to use slight force to pull the radio free. 2. The factory
antenna uses a micro-size jack. We recommend Radio Shack’s GM antenna adaptor (Cat. number 12-1336).
"B1" BRACKET
USE HOLE #3
"A1" BRACKET
"B1" SOPORTE USA
USE HOLE #2
LEFT SIDE
RIGHT SIDE
ABERTURA NO. 3
"A1" SOPORTE USA
LADO IZQUIERDA
LADO DERECHO
ABERTURA NO. 2
FRONT OF KIT
FRENTE DE
ESTUCHE
"C2" BRACKET USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
"B2" BRACKET USE HOLE #1
"B2" SOPORTE USA ABERTURA NO. 1
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
17