11
Installing the Pulley Guards (J075)
Thread the pulley guard stud into the hole under the
upper pulley (I).
Fit the upper pulley guard onto the stud, secure with a
flat washer and hex nut, and tighten the nut (J).
Place the lower guard backing plate behind the pulley
(K), then install the lower guard cover over the pulley
and backing plate (L).
I
J
K
L
Attach the lower guard to the backing plate using small
Phillips screws and flat washers (M). Then attach the
lower guard to the upper guard using pan head Phillips
screws and flat washers. (N)
Installing the Pulley Guard (J100)
Attach the pulley guard to the base using Phillips
screws and flat washers (O).
N
M
O
Installing the Dust Port
J075
Hang the dust port mounting bracket on the two motor
mounting bracket pins (A), then attach the dust port
using wing screws (B).
J100
Attach the dust port to the right side of the base using
Phillips screws and flat washers (C).
B
A
C
