7a - SURFACER USE AND ADJUSTING
EN
Pag.
12/15
- Cap.
7a
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7A.8
FENCE
(fs_7-8_0.0)
DANGER-WARNING
during the machining, the protections (F fig. 7.8) and (L fig. 7.8) must always be positioned on the
cutterblock.
CAUTION:
lifting and handling the guide should only be carried out by personnel specially trained to execute
this kind of operations, to prevent accidents or to prevent guide from being damaged.
DANGER-WARNING:
machining thin pieces.
To machine thin pieces use an auxiliary guide (not supplied by the
SCM
). In par. 10.3.1.10 there is
the information for the construction and installation.
7A.8.1
LONGITUDINAL SHIFTING
(fs_7-8-1_0.0)
-
Loosen lever (A fig.7.8)and manually move fence (B fig.7.8) to the desired position; tighten lever (A fig.7.8).
NOTE-INFORMATION:
check perfect cleanage of the sliding rod (E fig. 7.8).
7A.8.2
TILTING
(fs_7-8-2_0.0)
NOTE-INFORMATION:
fence (B fig. 7.8)may be tilted from 90° to 45° and in any intermediate position.
-
Release handle (C fig 7.8) to move the fence (B fig. 7.8) to the positions outlined above; lock the lever again
(C fig. 7.8).
-
As soon as the adjustment has been carried out, bring the fence lock (P fig. 7.8) to the stop on the surface
unit fence (B fig. 7.8) and tighten knob (R fig. 7.8).
NOTE-INFORMATION:
for eventual corrections of the stops for extreme positions (90° and 45°) operate on screw (D fig.
7.8) for 90° position and on screw (G fig. 7.8) for 45° tilting.
To gain access to the screw (G fig. 7.8) disassemble the rule (B fig. 7.8), after first loosening the
nuts (S fig. 7.8).
