EN
6 - SAW UNIT USE AND ADJUSTMENT
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Cap.
6
Pag.
7/11
6.4
CORRECT USE FOR CIRCULAR SAW
(mmax_6-4_0.0)
CAUTION:
first make sure that the machine does not vibrate.
Do not try to take off the material when the cut has already started; proceed with a continuous and
uniform speed.
Workpiece feeding towards the blade (especially where there are knots) should not be too fast
(feeding speed should be in accordance with workpiece thickness).
Do not let workpieces stop between the saw fence and the blade.
DANGER-WARNING:
always remove any trimmings produced during machining because trimmings interposed between
the blade and the saw table might damage the machine or be a source of danger for the operator.
Before removal, switch off the machine
and wait for the saw blade to stop.
-
Avoid contact of the tips against metallic objects.
-
When necessary sharpen the saw blade.
-
Often clean the steel body and the tips with proper liquid products. Let the saw blade in the bath, then clean
it with brush: don’t use metallic brushes.
-
As regards the toothing at least 2-3 teeth shall cut at the same time (A fig. 6.4). If only one tooth cuts (B fig.
6.4) you don’t get a good cutting.
-
Whenever this is possible, it is also critical to lift the blade until the whole tooth cutting part protrudes from
the wood thickness.
Fig. 6.4
