STC-7003
Telephone User Guide
*Note: If necessary, you may reset the user programmable
menu options to the original factory set by disconnecting the
telephone line, pressing and holding the ? and DIAL keys simul-
taneously, connecting the telephone line, then releasing both
keys after 2 seconds. All user options will be set to defaults and
all the contents of Caller ID messages and speed-dial memory
keys will be cleared.
Using a Headset
A standard telephone headset with a 2.5mm phone plug may
be used with the STC-7003 telephone. To use a headset, plug
it into the 2.5mm phone jack (labeled with a “headset” symbol)
located on the left side of the telephone. When the headset is
plugged in, the handset is disconnected and the headset must
be used for speaking and listening. To use the handset again,
unplug the headset from the telephone. When using a headset,
the handset hook switch controls the on-hook or off-hook state
of the phone. Remove the handset from its cradle to take the
phone off-hook and place the handset on its cradle to put the
phone on-hook.
Speed-dial Memory Key Labeling (optional)
1. Obtain a pin, sewing needle, knife blade, or similar pointed tool.
2. Press down on the center speed-dial key. Carefully insert the
tool in between the upper or lower edge of the pressed speed-
dial key and its hole in the faceplate. Pry up on the center of
the faceplate and lift upward to remove the faceplate from the
telephone.
3. Remove the transparent key caps from the nine speed-dial
keys. Insert labels of your choice between the keys and the
transparent key covers.
4. Orient the faceplate so that the two pins molded on the back
of the faceplate align with the corresponding holes on the tele-
phone body. Carefully reinstall the faceplate by inserting the
four tabs on the faceplate into the four retaining slots on the
telephone body.
Dialing using a Caller ID entry
On-hook
1) Press the Up or Down toggle to select the caller ID entry to
be dialed.
2) Press DIAL. The LCD will display “PICK UP OR ADJ “ for
10 digit numbers, or “PICK UP PHONE “ for 7 digit or 11 digit
numbers.
3) To adjust the phone number, press DIAL. For instance, a
7-digit local number sometimes cannot be dialed because it
requires a 10-digit or 11-digit format. Press DIAL repeatedly to
scroll through the 7, 10, and 11-digit numbers.
4) To dial the displayed number, pick up the handset or press
SPKR. The LCD will display “DIALING ...” and the number will
be dialed automatically.
Off-hook
With Local Area Code programmed
1) Select the telephone number variation to be dialed using the
Up and Down toggle keys.
2) If the displayed number is 10 digits, press the DIAL and the
LCD will display “DIALING ...”. The selected 10 digit number will
be prexed with a “1” and dialed automatically.
3) If a prexed “1” is not desired, press and hold the DIAL key
for 2 seconds. The LCD will display “DIALING...” and the 10
digit number will be dialed automatically.
4) If the displayed number is 7 digits, no adjustment can be
made.
With Local Area Code not programmed (default setting)
1) Press the Up or Down toggle key to select the number to be
dialed.
2) If the displayed number is 10 digits, press DIAL . The LCD
will display “DIALING...” and the 10-digit number will be dialed
automatically.
3) To prex the 10 digit number with a “1”, press and hold the
DIAL key for 2 seconds. The LCD will display “DIALING ...” and
a “1” followed by the 10 digit number will be dialed automati-
cally.
4) If the displayed number is 7 digits, no adjustment can be
made.
