TS-1084
Replacing the X-axis
Idler Pulley
Document Owner:
Service Department
Effective Date:
AUG-23-2022
Page 1 of 4
Purpose
This document provides the steps required to replace the X-axis idler pulley of the Sci-Print
VX2/VXL or RETROS instruments.
Intended Use
When the X-axis idler pulley needs to be replaced.
Required Material and Equipment
4mm allen wrench
3mm allen wrench
Intended Audience
Superuser
Procedure
1. Power off the instrument.
2. Remove the hood of the unit, and set aside.
3. Locate the X-axis idler pulley, shown in Figure 1 below.
Figure 1.
4. Use a finger to push against the belt, and take a mental note of the tension for later.
File Location: DMS
Revision A Approved Date: AUG-22-2023 Approved by: Service
