Hybex
®
Microsample Incubator — USER MANUAL
Version 1.
9
, Oct 2019 6 (408) 733-7337, [email protected]
II.
UNPACKING AND SET UP
A.
Unpacking the Heating Base
The Hybex Microsample Incubator heating base is shipped on its side within the interior
carton. Remove any packing material around the unit and lift the unit out; taking care not to
damage the hinged cover. Carefully inspect the heating unit for damage. Heat blocks and
other accessories are packaged separately from the heating base.
If there is evidence of damage, retain the shipping materials and contact SciGene
(
) or your local distributor for assistance.
B.
Items Provided
The following items are included with the Hybex heating base within the
re-closable plastic bag:
•
Power cord
•
User Manual
C.
Environmental Requirements
Ensure that the area where the incubator is installed meets the following conditions, for
reasons of safety and performance:
Ambient tempe15 to +32°C (58 to 90°F)
Relative humidity 15 to 80% RH non-condensing
Air flow clearance 3 inches (8 cm) minimum on both sides
D.
Installing the Instrument
1.
Place the unit on a level surface within a few feet of the power source. Ensure the
lid can be opened completely without interference and leave 3 inches of clearance
along the back and sides for air circulation.
2.
Plug the provided power cord into the back of the unit and then to a properly
grounded outlet. Use only the power cord provided.
Do NOT operate the system without a block inserted into the base unit!
Ne pas faire fonctionner le système sans un bloc insérée dans l'unité de base!
See
Section VII. ORDERING INFORMATION
for a list of available accessories and
Section III.
B. Handling Tube Blocks and the Waterbath Insert
for how to insert and remove blocks.
Allow 3 inches of
clearance on both sides
Allow 15 inches
of total vertical
clearance to fully
open the lid.
Allow 3 inches of
clearance at the back
for the power cord.