Method 1:Open the computer or mobile browser, enter the IP address displayed on the fourth line of the
OLED screen of the device in the address bar, and press Enter to enter the login page, as shown below:
If the NDI® Studio 4K has been set to the decoding mode, the screen will first display the
default initialization encoding state each time it is first powered on, and it will resume
displaying the currently set decoding state after waiting for about 10 seconds.
The PC or mobile phone must be in the same routing network as the NDI® Studio 4K device.
First Line---NDI Encoder / NDI Decoder/Optical Transmit
Displays the current NDI ® Studio 4K working modes: Encoding or Decoding.
The receiver or sender of the optical transceiver can only be used in coded mode.
Second Line---NDI Source Name / Primary HDMI/SDI Selection
In encoding mode, will displayed NDI stream name such as "NDI-X" that user could define this stream
name on Web UI
Displays the interface selected by the user's primary input, such as SDI or HDMI
In decoding mode, will display NDI source which was decoding on line, alternatively display ********* if
there is no NDI source was selected.
Third Line--- IN: 1080I50 / CH: SDI-Y HDMI-N
Displays the video format of the current input source of the device (when the device serves as an
optical receiver, the video format of the optical input is displayed) and whether the SDI and HDMI
inputs are detected (Y indicates that there is an input and N indicates that there is no input).
Fourth Line---OUT: 2160p60 / 192.168.3.166
Display the output format after Up/Down conversion selected by the user
Displays the current IP address of the device
5. Login Web UI
06