Your StingRay Electric will provide years of fun, if properly cared for and maintained. If you find damaged or
worn parts,
DO NOT
use the StingRay Electric. Refer to "Service and Repairs" on page 5 to order new parts
or find an authorized repair center.
CLEANING
Keep your StingRay Electric clean so it will look good and perform at its best.
DO NOT
allow mud to dry on
the StingRay Electric.
ALWAYS
remove mud, brush, grass or excessive dirt from the StingRay
Electric after every ride. Proper cleaning can extend the life of the StingRay Electric.
WARNING
• DO NOT
allow water contact with the brakes, ignition, charging outlet or other electrical parts.
• DO NOT
operate the StingRay Electric if the brakes are wet. Allow the brakes to dry thoroughly
before using the StingRay electric.
• DO NOT
use high-pressure washers, such as those found at coin-operated car washes to clean the
StingRay Electric. The high pressure can cause damage to the body, moving and electrical parts.
• Use a garden hose at low pressure to wash the majority of dirt or other debris from the StingRay Electric.
• Hand wash with mild soap and water using a soft rag or mitt.
DO NOT
use a brush that could scratch the
finish or other plastic surfaces.
DO NOT
use abrasive cleansers.
• Rinse thoroughly with clean water. Dry with a chamois or soft, absorbent cloth.
DO NOT
use wax.
• Park the StingRay Electric indoors or under cover.
DO NOT
allow it to sit in the rain.
• Keep the StingRay Electric away from heat, such as heaters and stoves. Plastic parts may melt.
CARE AND MAINTENANCE
14
