25
Note:
Your machine may not match the image. For reference only.
Tools required:
pedal wrench, flathead screwdriver, #2 Phillips
screwdriver, 13 mm open end wrench or socket and wrench
1.
Remove the Pedals. Refer to the “Replacing the Pedals”
procedure in this manual.
2.
Carefully remove the Shrouds, Console and Vent Cover. Refer
to the “Replacing the Shrouds and Vent Cover” procedure in this
manual. Set the hardware safely aside for reassembly.
3.
Remove the Right Rear Fan Cover. Refer to the “Replacing
the Fan Covers” procedure in this manual. Set the hardware safely
aside for reassembly.
Note:
It may also be necessary to remove the Front, Left Rear
and Bottom Fan Covers.
4.
Make a note of the setting of the Belt Tensioner (A): the
number of bolt threads showing. To loosen the belt tension, turn the
upper nut (B) and lower nut (D).
5.
Slowly turn the Drive Pulley (E) backward and carefully ease
the Drive Belt (F) off the Drive Pulley to the outside.
Be sure to keep fingers clear of all pinch hazards as
you turn the Drive Pulley.
6.
Remove the Drive Belt (F) from the Belt Tensioner (A).
Disconnect the data cable from the console before you service this machine.
Replacing the Belt Tensioner Assembly (Idler Assembly)
F
E
A
A
B
D
