Schweitzer Engineering Laboratories SEL-700G Series, Instruction Manual

Page: 343 / 824

4.237
Date Code 20170814 Instruction Manual SEL-700G Relay
Protection and Logic Functions
DNP Map Settings (SET DNP n Command, n = 1, 2, or 3)
Load Profile Settings
Use the LDLIST setting to declare the analog quantities you want included in
the Load Profile Report. Enter as many as 17 analog quantities, separated by
spaces or commas, into the LDLIST setting. See Appendix K: Analog
Quantities for a list of the available analog quantities. Also set the LDAR to
the acquisition rate you want for the report.
IMPORTANT:
All stored load data
are lost when you change the LDLIST
setting.
DNP Map Settings (SET DNP n Command, n = 1, 2, or 3)
Table 4.99 shows the available settings. See Appendix D: DNP3
Communications for additional details.
Table 4.97 Generator Autosynchronism Report Data
Data Description Remarks
Analog Data:
DELTA_VOLT
VS
SLIP_FREQ
FREQS
DELTA_ANGLE
(From Figure 4.105)
Vpxc_Mag–Vs_Mag
Vs_Mag * PTRS
FREQX–FREQS
FREQS
Vxs_Angle
See Appendix K: Analog Quantities
for additional descriptions (FREQS
is the frequency of synchronism-
check voltage input, and PTRS is
the setting).
Digital Data:
59VPX, 59VSX, GENVHI, GENVLO VDIFX, GENFHI,
GENFLO, SFX, 25AX1, 25AX2, 25C, CFA, BKRCF, FSYNCST,
VSYNCST, 52AX, VSYNCTO, FSYNCTO, ASP, AST, VRAISE,
VLOWER, FRAISE, FLOWER, VSYNCACT, FSYNCACT,
SV27T, SV28T, SV29T, SV30T, SV31T, SV32T
Relay Word bits See Appendix J: Relay Word Bits
for descriptions. Use unassigned
variables SV27–SV32 to enhance
the report as necessary (see
Table 4.57).
Table 4.98 Load Profile Settings
Setting Prompt Setting Range
Setting Name :=
Factory Default
LDP LIST 0, as many as 17 Analog
Quantities LDLIST := 0
LDP ACQ RATE 5, 10, 15, 30, 60 min LDAR := 15
Table 4.99 DNP Map Settings
a
(Sheet 1 of 2)
Setting Prompt Setting Range
Setting Name :=
Factory Default
DNP Binary Input Label Name 10 characters BI_00 := ENABLED
DNP Binary Input Label Name 10 characters BI_01 := TRIP
DNP Binary Input Label Name 10 characters BI_02 := TRIPX
DNP Binary Input Label Name 10 characters BI_03 := STFAIL
DNP Binary Input Label Name 10 characters BI_04 := STSET
DNP Binary Input Label Name 10 characters BI_05 := IN101
DNP Binary Input Label Name 10 characters BI_06 := IN102
·
·
·
DNP Binary Input Label Name 10 characters BI_99 := NA
DNP Binary Output Label Name 10 characters BO_00 := RB01