Schweitzer Engineering Laboratories SEL-2100, Instruction Manual

Page: 195 / 206

S
ETTINGS
S
HEET Page 13
OF
14
FOR THE
SEL-2100
Date
S
ERIAL
P
ORT
S
ETTINGS
(S
ERIAL
P
ORT
C
OMMAND
SET P)
Date Code 20010529 Settings Sheets H-13
SEL-2100 Instruction Manual
Port setting information not described elsewhere in this instruction manual:
Minutes to Port Time-Out: Set T_OUT to the number of minutes of serial port inactivity for
an automatic log out. Set T_OUT = 0 for no port time-out.
Number of Lines in Terminal: Set TLINES to the number of lines displayed on the terminal
before the “Press RETURN to continue” prompt is displayed and line scrolling is paused. Set
TLINES = OFF for line scrolling without pauses.
Send Auto Messages to Port: Set AUTO = Y to enable AUTO messages on the serial port.
Automatic messages are ASCII messages sent to the port to indicate a power on condition or
status failure without a user request. Set AUTO = N to disable AUTO messages.
Fast Operate Enable: Set FASTOP = Y to enable binary Fast Operate messages on the serial
port. Refer to Appendix E: Fast Meter Protocol for a description of Fast Operate commands.
Set FASTOP = N to disable this feature.
Port Number (1—16) Port =
Protocol = DNP
Refer to Appendix C for more details about DNP V3.00 protocol.
Protocol Setting PROTO = DNP
Baud Rate (300, 1200, 2400, 4800, 9600, 19200, 38400) SPEED =
DNP Address (0–65534) DNPADR =
Class for Binary Event Data (0–3) CLASSB =
Class for Counter Event Data (0–3) CLASSC =
Minutes for Request Interval (0–32767) TIMERQ =
Seconds to Select/Operate Time-Out (0.0–30.0) STIMEO =
Data Link Retries (0–15) DRETRY =
Seconds to Data Link Time-Out (0–5) DTIMEO =
Minimum Seconds from DCD to Tx (0.00–1.00) MINDLY =
Maximum Seconds from DCD to Tx (0.00–1.00) MAXDLY =
Settle Time from RTS ON to Tx (OFF, 0.00–30.00 sec) PREDLY =
Settle Time from Tx to RTS OFF (0.00–30.00 sec) PSTDLY =
Seconds to Event Message Confirm Time-Out (1–50) ETIMEO =
Enable Unsolicited Reporting (Y, N) UNSOL =
Enable Unsolicited Reporting at Power-up (Y, N) PUNSOL =
DNP Address to Report (0–65534) REPADR =
Number of Events to Transmit On (1–200) NUMEVE =
Seconds Until Oldest Event to Tx On (0.0–60.0) AGEEVE =