schwa-medico
Instructions for Use - TENS eco 2
14
Switching ON/OFF the buzzer
Pressing the left
key for three seconds, with
keyswitching ON/OFF.
Factory settings
The parameters from P1 and P13 are identical in new devices, respectively for P2 and
P14, P3 and P15, … P12 and P24.
Switching OFF the TENS unit
Press the
key to switch OFF the TENS eco 2. If the battery level is too low or if the
TENS unit has not been used for the previous 2 minutes, it turns off automatically.
Charging the battery
The battery level is shown on the display with a battery symbol with 4 lines. If the
battery level is too low the TENS unit switches OFF automatically and cannot be turned
on again. The battery needs to be re-charged.
»
Switch the commutator to the OFF position (no. 8).
»
Connect the charger with the TENS eco 2 (socket no. 7).
»
Connect the charger to the mains circuit. The diode on the charger illuminates in red.
»
Charge the TENS unit until the diode on the charger illuminates in green.
»
The battery is fully charged if the light on the charger appears in green. Plug OFF the
charging cable from the mains circuit.
Caution! Do not charge the battery for more than 3 hours.
Important! Do not forget to switch the commutator ON again after charging.
Socket
Commutator
Setting date and time (for memory query mode)
Before you can use the memory query mode you need to set the date and time.
Pressing and holding the
key for about 3 seconds leads you to the date/time mode.
In date/time mode the LCD shows two figures: The left figure indicates the date, the
right figure indicates the time.
»
Pressing the left
key increases the date by one day (max. 30).
»
Pressing the left
key decreases the date by one day (min. 1).
»
Pressing the right
key increases the time by one hour (max. 23).
»
Pressing the right
key decreases the time by one hour (min. 0).
»
Press the
key to save all parameters and to leave the date/time mode again. Date and
time are continuously updated.
Summary of Contents for TENS eco 2
Page 23: ...English 23 ...
