schwa-medico Operating Instruction - EMP 2 PRO
Operating the EMP 2 PRO
Switching on the device
Switch on the device using the key. The EMP 2 PRO starts with the programme
number which was active when the device was last switched off.
Using the 230-Volt mains supply (optional)
After having connected the transformer to your 230-Volt socket, connect the
cable to the power supply socket in the front face of the appliance between the
channel outlets 1 and 2. It should be noted that when the machine is connected
to the transformer connected to the 230-Volt mains supply it will operate from
the mains supply and not the battery.
Activating the editing mode
Only if you switch on the EMP 2 PRO pressing the
key, you can activate the
standard programmes (please refer to section entitled “Activating the editing
mode“) and make copies of them in the form of user programmes. However, this
function is only available if the device was not locked beforehand.
Resetting the operating
parameters and deleting
the user programmes
If you wish to delete the user programmes and return the operating time meter,
the cycle meter and the mean stimulation intensity to zero, keep the key on
the left and the
key pressed down while switching on the device (please
refer to section entitled “Resetting the operating parameters“).
Programme selection
Use the
key to change to the next standard or user programme. However,
this is only possible with an unlocked device. The standard programmes 1 to 20
marked with a ”P“ run initially, followed by the user programmes marked with
an ”U”, if present. When the last programme has been reached, pressing the
key again returns the setting to programme 1 (P1).
Starting stimulation
First, position the electrodes at the desired points of the body and connect
the electrode cables to the electrodes and the device. When the desired pro-
gramme has been selected using the modification key, or the
key
increase the intensity (Fig. 2), the two keys may be used to start stimulation. In
