schwa-medico Operating Instruction - EMP 2 PRO
Deleting the user
programmes
To delete all user programmes, keep the
key and the key on the left
pressed down when switching on the device. This will also return all operating
parameters to zero.
Description of parameters
These values are used to check the patient’s stimulation behaviour. The fol-
lowing information are reported by the EMP 2 PRO: The stimulation time (Fig.
13) is the total time during which stimulation was carried out with the device.
The cycles (Fig. 14) mark how often the device was switched on and concomi-
tantly used for stimulation. The mean stimulation intensity (Fig. 15) is the mean
value of all values for current set by the patient. This information is registered
separately for the two channels. The values are updated every minute during
stimulation. However, only intensities above 4 mA are considered.
Calling up the parameters
Press the key on the left and the
key at the same time. The stimulation
time in hours and minutes is first shown in the upper part of the display. The
number of cycles is shown in the lower part of the display.
After pressing the
key, the mean stimulation intensity for channel 1 is
shown in the lower left part of the display, that for channel 2 in the lower
right part.
Resetting the operating
parameters
To reset all the described values to zero, keep the key on the left and the
key pressed down when switching on the device. Please be aware that all
user programmes are also deleted.
Switching off the device
Use the key to switch off the device. If the battery voltage has fallen below
a critical value, or if no key is pressed for two minutes outside stimulation, the
device switches itself off automatically. This is signalled by a beep.
