Maintenance and care
8 Maintenance and care
SCHUNK TOOLFIX mounting systems are designed for low-
maintenance operation, so opening and disassembling the
mounting system is only necessary in exceptional cases.
If the TOOLFIX mounting system needs to be disassembled, this
may only be performed by trained specialist personnel.
• Clean all the parts thoroughly and check for damage and wear.
Damaged and worn parts must be replaced.
Replace damaged parts with original SCHUNK spare parts only.
A functional check must be conducted before commissioning.
General operating conditions
• Ensure that the insertion surfaces of the toolholder tapers are
always clean.
• Always ensure that no chips of any kind enter the interface of
the change components.
• According to the principle of preventive maintenance, the
maintenance and inspection activities listed in the following
chapters must be carried out at the respective intervals.
• In the event of malfunctions in the course of the following
inspection work, the system must be taken out of operation
immediately and only restarted after maintenance and a
successful inspection.
31
01.00 | | TOOLFIX modular tool mounting device | en | 1510829
