Maintenance
34
04.00|ROTA FSW |en
rosion protection and is not lubricated depending on the function.
Lubrication is only envisaged on the mechanical running surfaces.
To avoid axial and radial concentricity errors:
• Only lubricate the corresponding surfaces lightly.
• Avoid lubricants entering the areas between clamping elements
and the guide cone.
Following a collision:
• If the ROTA FSW chuck quick-change and the clamping device
are involved in a collision, they must be tested for cracks before
using them again.
Damaged parts must be replaced with origi-
nal SCHUNK spare parts.
• Replace the mounting screws if there are signs of wear or dam-
age. Only use screws of equivalent quality.
Tighten the screws with the specified torque (see "Screw
torques" chapter.
Period of maintenance
Operating hours
Activity
Each time after the
clamping device is
changed
Visually inspect all parts, taking
particular care to check the mount-
ing taper and flat surfaces for
damage. Clean and lubricate the
flexible adapter and draw tube
adapter and contact surfaces. Make
sure that the O-ring is fitted in the
draw tube adapter.
Every 2 weeks or after 5
clamping tool changes
Perform visual inspection of the en-
tire system and lubrication nipples.
Every 1200 hours, when
replacing the flex adapter
and draw tube adapter,
or as required
Full cleaning with detachment,
disassembly, and visual inspection
of all individual components of the
FSW chuck quick-change
Depending on wear, but at the latest 250,000 or 5,000 changes of
the clamping device, the flexible adapter and draw tube adapter
must be replaced.
8.3
