_________________________________________________________________________________________
schunk.com
XND.00034.002_A – 10/2018
26
3.1
Application
3.1.1
Adjusting jaws
For two identically sized or differently sized workpieces
Important:
the lateral clamping screw (pos. 200) has not been tightened, open by
approximately ½ turn.
Fully open the vice and position as well as secure the moving clamping jaws in the matching
grooves of the moving carriages depending on the workpiece size.
System jaws must be secured using M10 cylinder screws with property class 12.9, clamping
torque 60 Nm.
It is also possible to clamp two workpieces with different sizes.
The maximum carriage adjustment range using the threaded spindle is 31 mm per carriage.
If this is insufficient to clamp the workpiece, install the jaws in a different groove of the
carriage. The grooves are spaced 25 mm apart.
