Assembly and settings
04.00 - FW 2.x | EGL | Assembly and Operating Manual | en | 389661
55
■
There is new firmware on the USB flash drive
■
The power supply is disconnected from the product
■
DIP switches "1" and "2" are in "OFF" position
Ø
Connect the USB flash drive to the USB Micro AB, host.
Ø
Switch on the power supply of the product.
✓
LED 1 and LED 2 light up green.
✓
LED 6 lights up green.
✓
LED 4 lights up red for approx. 5 seconds.
✓
After LED 4 goes out, LED 3 lights up yellow for approx. 5
seconds.
✓
After LED 3 goes out, LED 4 lights up red.
Ø
Switch DIP switch "1" to "ON" position.
✓
LED 1 and LED 2 light up green.
✓
LED 6 lights up red.
✓
LED 3 lights up yellow.
✓
LED 4 flashes red once.
Ø
Switch DIP switch "2 "to "ON" position.
✓
LED 1 and LED 2 light up green.
✓
LED 6 lights up red.
✓
LED 3 lights up yellow.
✓
LED 4 flashes red once.
NOTE
The logic board is being updated.
• Do not disconnect the product from the power supply.
✓
LED 4 flashes red rapidly.
✓
LED 4 lights up red for approximately 10 seconds and goes
out.
Ø
The adapter board update is finished.
Ø
Disconnect the product from the power supply.
Ø
Disconnect the USB flash drive from the USB Micro AB, host.
Ø
Switch DIP switches "1" and "2" to "OFF" position.
