Maintenance
Spindle Supply
Fitting Assembly
Rubber Disk
Internal Retaining Ring
Pivot Pin
(2x) M5
Set Screws
Pivot Pin
Front Housing
Gimbal Ring
Air Motor
Assembly
Rear
Post
30. Insert the new air motor and gimbal assembly into the front
housing assembly.
31. Insert the pivot pins to secure the air motor in place. Make
sure the wave spring remains in place.
Gimbal Ring
(2x) M4
Set Screws
Threaded Bushing
1.3 mm Allen Wrench
32. Using a 4 mm Allen wrench, install the 2 M5 set screw into the
front housing assembly to secure the pivot pins. Tighten to
2.82 Nm.
33. Using a 1.3 mm Allen wrench inserted into the side hole of the
threaded bushing, turn the bushing in toward the housing until
contact then back it off 1/6 of a turn (one through hole).
34. Using a 2 mm Allen wrench, tighten the 2 M4 set screws at the
bottom of the gimbal ring to 2.82 Nm.
43
04.00 | FDB | Assembly and Operating Manual | en | 389072
